Upgrade TiDB Binlog

This document introduces how to upgrade TiDB Binlog that is deployed manually to the latest cluster version. There is also a section on how to upgrade TiDB Binlog from an earlier incompatible version (Kafka/Local version) to the latest version.

Upgrade TiDB Binlog deployed manually

Follow the steps in this section if you deploy TiDB Binlog manually.

Upgrade Pump

First, upgrade each Pump instance in the cluster one by one. This ensures that there are always Pump instances in the cluster that can receive binlogs from TiDB. The steps are as below:

  1. Replace the original file with the new version of pump.
  2. Restart the Pump process.

Upgrade Drainer

Second, upgrade the Drainer component:

  1. Replace the original file with the new version of drainer.
  2. Restart the Drainer process.

Upgrade TiDB Binlog from Kafka/Local version to the cluster version

The new TiDB versions (v2.0.8-binlog, v2.1.0-rc.5 or later) are not compatible with the Kafka version or Local version of TiDB Binlog. If TiDB is upgraded to one of the new versions, it is required to use the cluster version of TiDB Binlog. If the Kafka or local version of TiDB Binlog is used before upgrading, you need to upgrade your TiDB Binlog to the cluster version.

The corresponding relationship between TiDB Binlog versions and TiDB versions is shown in the following table:

TiDB Binlog versionTiDB versionNote
LocalTiDB 1.0 or earlier
KafkaTiDB 1.0 ~ TiDB 2.1 RC5TiDB 1.0 supports both the local and Kafka versions of TiDB Binlog.
ClusterTiDB v2.0.8-binlog, TiDB 2.1 RC5 or laterTiDB v2.0.8-binlog is a special 2.0 version supporting the cluster version of TiDB Binlog.

Upgrade process

If you want to resume replication from the original checkpoint, perform the following steps to upgrade TiDB Binlog:

  1. Deploy the new version of Pump.

  2. Stop the TiDB cluster service.

  3. Upgrade TiDB and the configuration, and write the binlog data to the new Pump cluster.

  4. Reconnect the TiDB cluster to the service.

  5. Make sure that the old version of Drainer has replicated the data in the old version of Pump to the downstream completely;

    Query the status interface of Drainer, command as below:

    curl 'http://172.16.10.49:8249/status'
    {"PumpPos":{"172.16.10.49:8250":{"offset":32686}},"Synced": true ,"DepositWindow":{"Upper":398907800202772481,"Lower":398907799455662081}}

    If the return value of Synced is True, it means Drainer has replicated the data in the old version of Pump to the downstream completely.

  6. Start the new version of Drainer.

  7. Close the Pump and Drainer of the old versions and the dependent Kafka and ZooKeeper.

Was this page helpful?